应急发电机试验程序.pdfVIP

Emergency D/G and ESB Test Procedure HT408-M-TP05 PAGE 应急发电机和应急配电板试验程序 2 / 11 1 SCOPE 适用范围 This test procedure shall be applied to the operation function test of Emergency diesel generator and Emergency switch board for 57000DWT Bulk Carrier. 本程序适用于57000吨散货船应急发电机与应急配电板的操作及性能测试. 2 PARTICULARS 摘要 Technical data 主要参数 Engine type ：6CTA8.3-D(M) 柴油机型号：6CTA8.3-D(M) Engine Rated Power : 181 Kw 柴油机额定功率：181 kw Speed : 1800 r/min 转速：1800 r/min Gen sets rated power :99Kw 发电机额定功率：99Kw Frequency : 60Hz 频率: 60Hz Cos phi : 0.8 功率因数：0.8 Rated current : 158.77 额定电流：158.77A Rated voltage: 450 额定电压：450V 3 TEST CONDITION 试验条件 3.1 Emergency D/G and concerning system install correct. 应急发电机机组、相关管系及油柜安装正确完整. 3.2 Check the L.O cooling water quality. 检查滑油和冷却水品质. 3.3 ESB install and cable connection 应急配电板的安装和接线验收合格； 3.4 ESB insulation resistant and others test finished. 应急配电板的绝缘电阻及其它测试合格. 4 TEST PROCEDURE 试验程序 4.1 The cold state Insulation resistance of Stator/Rotor/Excitation/Heater should AREA : 0.0625 m2 Emergency D/G and ESB Test Procedure HT408-M-TP05 PAGE 应急发电机和应急配电板试验程序 3 / 11 be measured before the test. Insulation resistance should be no more than 1 M Ω.  试验前，定子、转子、励磁、加热器应进行冷态的绝缘测量  绝缘电阻大于 1 M Ω.  4.2  Alarm and safety function tests 报警与安全保护试验  According to attached table 参照附表   4.3 Starting test 启动试验    Starting test shall be carried out three times consecutively under no load and room temperature condition. 启动试验应在机组无负荷和室温条件下连续启动