单片机STM32外文文献翻译、中英文翻译.doc

外文翻译 英文原文： STM32 Microcontroller Introduction Requirements based STM32 family is designed for high-performance, low-cost, low-power embedded applications designed specifically for ARM Cortex-M3 core. According to the performance into two different series: STM32F103 Enhanced series and STM32F101 Basic series. Enhanced Series clock frequency of 72MHz, the highest performance of similar products product; basic clock frequency of 36MHz, 16-bit product prices get more than 16 products significantly enhance the performance and is 16 product users the best choice. Both series have built-in 32K to 128K of flash memory, the difference is the maximum capacity of the SRAM and peripheral combinations. At 72MHz, executing from Flash, STM32 power consumption 36mA, are 32 products on the markets lowest power, the equivalent of 0.5mA/MHz. STM32F103 Performance Characteristics Kernel. ARM32 bit CPU, the maximum operating frequency of 72MHz, 1.25DMIPS/MHz. Single-cycle multiply and hardware divide. Memory. Integrated on-chip 32-512KB of Flash memory. 6-64KB SRAM memory. Clock, reset, and power management. 2.0-3.6V power supply and I / O interface, the drive voltage. POR, PDR and programmable voltage detector. 4-16MHz crystal. Embedded factory tuned 8MHz RC oscillator circuit. 40 kHz internal RC oscillator circuit. CPU clock for the PLL. With calibration for the RTC 32kHz crystal. Low power consumption. Three kinds of low-power mode. Sleep, stop, standby mode. For RTC and backup registers supply VBAT. Debug mode. Serial debugging and JTAG interface. Direct data storage. 12-channel direct data storage controller. Supported peripherals: timers, ADC, DAC, SPI, IIC and USART. Up to a maximum of 112 fast I / O ports. Depending on the model, there are 26,37,51,80, and 112 I / O ports, all ports can be mapped to 16 external interrupt vectors. In addition to the analog input, all of them can accept the input of 5V or less. Up to a maximum of 11 timers. Four 16-bit timers, each with 4 IC /