英文版本MSDSABS塑胶.docxVIP

Material Safety Data Sheet ABS Product and Company Information Product Name: ABS Company Name:某某公司 Company Address: 某某地址 Name of people in charge: 某某姓名 TEL: 00002. Hazard Introduction Inhalation: Under the molten state , the gas produced by raw materials may induce some stimulation to the respiratory organs Eye contact: Solid or particle shape materials may cause some stimulation to the eyes in eye contact. Skin contact: Under general condition, will not cause stimulation to skin. Chronic response: None Carcinogenicity: None 3. Composition /Information on Ingredients Single/compound: Compound Chemical name: ABS Chemical Components CAS No. Proportion of Ingredients (%) ABS 9003-56-9 74% TPR------- 5% Fire retardant 917-23-7 20% Color master 1333-86-04 1% 4. Emergency Treatment Inhalation: Under general condition, it ’s impossible to inhale solid colloidal particles. But when inhale overmuch gas produced by molten resin, should take a breath under fresh air, adopt artificial respiration whennecessary. Accept medical treatment when necessary. Skin contact: No apparent symptoms, wear working gloves when necessary. Eye contact: Only causes physical wounds, remove the foreign bodies will be OK. Accept medical treatment when necessary. Fire-fighting measures Hazardous characteristics: None Hazardous comburent: During thermal decomposition, may probably emit toxic or dangerous gases Extinguishing method: Powder fire extinguishing agent, carbon dioxide, water spray and foam Emergency Handling of Leakage Emergency treatment: None Safety Handing and Storage Cautions: No open fires in the storage places; Store under normal indoor condition. 8. Contact Control and Personal Protection Operation control: Keep the site with adequate air ventilation. Wear a gauze mask during operation. Respiratory protection: Whenthe air concentration is above normal standard, shall wear gas mask. Eye protection: wear safety glasses when necessary. Body protection: No special requirem