ABB Pluto安全PLC 偏心压力机功能块说明.pdf

Original instructions PLUTO Safety-PLC Description of function blocks Eccentric presses English v1A 2TLC172010M0201_A Table of contents: 1 Safety Note 3 2 Description of function blocks 4 2.1 EPress1 4 2.2 EPressTHand3 5 2.3 ValveMonE1 6 3 Cam arrangement 7 3.1 Logic function 7 3.2 Examples of physical arrangement of mechanical cam systems. 8 2 2TLC172010M0201_A 1 Safety Note In the function blocks EPress1 and EpressTHand1 the input “Guard” is only a single channel input without reset function. Presses have often doors and hatches with dual channel switches, sometimes also requiring reset function. For these cases the switches and reset button must be connected to a standard block such as “TC2RTI” or “TC1Sim” whose output then is connected to the input “Guard”. 3 2TLC172010M0201_A 2 Description of function blocks 2.1 EPress1 Eccentric press block with three modes of operation: Single stroke mode, Setting mode and Automatic mode Function In single stroke mode the block controls a single press stroke containing of start with the input “RunSingleStr”, take over function and stop in top position. Take over is the position where the input “RunSingleStr” can be released. To get take over the press stroke must be started from top position. If the stroke is started from another position than top or interrupted during the down stroke the take over function is not activated. In setting mode the movement is also started by the input “RunSingleStr” but the take over function is not active. During downstroke the movement is interrupted by the timer fu