LED注意事项及回流焊示意图.docxVIP

深圳市欣华信光电科技有限公司 SHENZHEN XINHUAXIN OPTOELECTRONIC TECHNOLOGY CO.,LTD LED 注意事项 [一]引脚成形方法 Led bracket forming method 必须离胶体 2 毫米才能折弯支架。 The pin of led can be bent where is at least 2mm out of led colloid 支架成形必须使用或由专业人员来完成。 Must use fixture to deform the led bracket. 支架成形必须在焊接前完成。 Finishing the forming of led bracket must be before soldering. 支架成形需保证引脚和间距与线路板上一致。 Guarantee the gap between two pin of led tallys with LED pads in PCB when forming. [二]回流焊接 Manual soldering 焊接处必须离胶体位置 2 毫米以上。 The welding must from colloidal position above 2 mm. 可靠性焊接温度下图 Reliability welding temperature below 回流焊图 Soldering Heat Max240°CConstant temperature 180°C[三 Soldering Heat Max240°C Constant temperature 180°C 静电及高压会对 LED 造成损坏，特别是晶片材质为 InGaN 的产品对静电防护的要求更加严格，要求在使用和检验产品时带防静电手腕带或防静电手套，焊接工具及设备的外壳需可靠接地，焊接条件遵循此份规格书中条件。 Static electricity and higt volt can damage led ，The production whose Die material is InGaN must strictly required to prevend ESD，Must put on static glove and static fillet，Soldering tool and the cover of device must connect the ground，Soldering condition follows the related staing of production specification manual. 深圳市欣华信光电科技有限公司 SHENZHEN XINHUAXIN OPTOELECTRONIC TECHNOLOGY CO.,LTD [四]过电流保护 Protecting countermeasure when over current 为避免由于电压的变化引起大电流冲击而造成产品损坏，需要加入保护电阻。 Need add the protecting resistor in circuit in order to avoid damaging led due to big current and voltage fluctuation。 [五]LED 的安装方法 LED installation method ①注意各类器件外线的排列以防极性装错，器件不可与发热元件靠得较近，工作条件不要超过其规定的极限。 Pay attention to the led polarity and avoid installation wrong，Led can’t be close to euthermic component,work condition should tally wish it’s specification. ②务必不要在引脚间距变形的情况下安装 LED Don’t install the LED under the condition of the led pin deformation. ③当装配 LED 进入 PCB 或者装配孔时，LED 不能承受任何压力。 The led bracket don’t load any pressurs when installing the led into PCB or fitting hole ④在焊接温度回到正常以前，必须避免使 LED 受到任何的震动或外力。 Must avoid any strike and force on led before the soldering temperature return to room temperature.