思科网络学院第十一单元答案.docxVIP

1 Immediately after a router completes its boot sequence, the network administrator wants to check the privileged EXEC mode, which of the following commands can the administrator use for this purpose? ( show flash show NVRAM show startup-config show running-config show version 2 Users in the network are experiencing slow response time when doing file transfers to a remote server to determine if the router has experienced any input or output errors? show running-config show startup-config show interfaces show ip route show version show memory 3 Refer to the exhibit. A technician applies the configuration in the exhibit to a clean router. To verify the configuration, the technician issues the show running-config command in the CLI session with the router. What lines should the technician expect to see in the router output from theshow running-config command? enable password class line console 0 password ccna enable secret cisco enable password class line console 0 password ccna enable secret 5 $1$v0/3$QyQWmJyT7zCa/yaBRasJm0 enable password class line console 0 password ccna enable secret cisco enable password 7 14141E0A1F17 line console 0 password 7 020507550A enable secret 5 $1$v0/3$QyQWmJyT7zCa/yaBRasJm0 enable password 7 14141E0A1F17 line console 0 password 7 020507550A 4 Refer to the exhibit. A network administrator on HostA has problems accessing the FTP server. Layer three connectivity te successful from HostA to the S1 interface of RouterB. Which set of commands will allow the network administrator to telnet and run debug commands? RouterB(config)# enable secret class RouterB(config)# line vty 0 4 RouterB(config-if)# login RouterB(config)# enable secret class RouterB(config)# line vty 0 2 RouterB(config-vty)# password cisco RouterB(config-vty)# login RouterB(config)# enable secret class RouterB(config)# line vty 0 RouterB(config-line)# password cisco RouterB(config-line)# login RouterB(config)# enable secret class RouterB(config)# line aux 0 RouterB(config-line