浅谈地震勘探采集方法的改进.docxVIP

浅谈地震勘探采集方法的改进 u2004方法 su模子、泛在三维研讨会设计、菲菲诺伊省魅力分析、进程技术等。重点关注改进的低级别家庭结构、菲菲诺伊省魅力分析、标准技术等。首先，确保目标区域的能源阴影区域由项目实施。氮省预算区域应考虑目标区域阴影区域的能量，预算区域应考虑阴影区域的能量。重点关注天花板上的区域。采用自我评估方法，在框架内使用目标区域的能量，重点关注框架内的区域压力。 shctincipar.3.3srexh认识/设计背景下的sh科多态性二十四首 The purpose of local infi lling shots is to increase the illumination energy of the shadow area of the target layer.This target-orientated shot method is different from the total infill shot method, which only considers surface conditions.Therefore, it avoids redundant shot points.The basics of the method are the following. First, a dense geometry of shot points is designed based on the work area model and seismic wave illumination modeling is carried out, resulting in concentrating the energies from all shots (see Figure 1) .This illumination energy is received by the underground CRP bin, which is similar to the energy after migration, and the sum of the received energy from this bin is expressed as where s where s Fourth, the shot point where the energy maximum i nearest to the target-layer energy shadow area (see gray points in the Figure 1) is located where where E 2 Dmodeltesting shctraftingmotisiphinfilling状况 The 2D model is built based on the through-well seismic section of an oilfield in western China (Figure2) with a relatively complex structure.Both sides of the model were equally broadened to adapt to the geometry layout.Seismic illumination energy data were acquired by Gaussian beam forward modeling.Single-shot data were obtained by the forward wave equation and the final profile was obtained by prestack depth migration for comparing the target-layer energy before and after the infi lling shots.The model parameters are the model effective length (6900 m) , the extend length (30900m) , and the depth (6000 m) .The horizontal and vertical sampling interval is 10 m and 20 m, respectively.The forward modeling geometry parameters are the trace space (30 m) , the shot space (60 m) , the base shot space (360 m) , the number of traces