不锈钢管混凝土的粘接滑移性能研究.docVIP

  不锈钢管混凝土的粘接滑移性能研究# 陶忠1，韩林海2* （1. 福州大学土木工程学院，福州 350108； 5 10 15 20 25 2. 清华大学土木工程系，北京 100084） 摘要：通过推出试验研究了不锈钢管和混凝土之间的粘接滑移性能，并与普通钢管混凝土的 推出试验结果进行了对比。试验表明由于不锈钢较普通钢表面更为光滑，不锈钢管混凝土的 粘接强度要低于普通钢管混凝土的粘接强度。根据本文试验结果，建议对实际工程应用中尺 寸较大的不锈钢管混凝土柱或采用的混凝土收缩较大的情况下，应采取必要的措施来提高不 锈钢管混凝土的粘接强度。 关键词：结构工程；钢管混凝土；不锈钢；粘接强度；推出 中图分类号：TU398 Bond behaviour in concrete-filled stainless steel hollow sections TAO Zhong1, Han Linhai2 (1. College of Civil Engineering, Fuzhou University, Fuzhou 350108; 2. Department of Civil Engineering, Tsinghua University, Beijing 100084) Abstract: This paper studies the bond strength between the stainless steel tube and concrete in concrete-filled stainless steel tubes (CFSST). Push-out tests were conducted to compare the bond strength in CFSST columns with that of reference specimens with carbon steel tubes. The test results indicate that the internal surface of a stainless steel tube is usually smoother than that of a carbon steel tube. For this reason, when stainless steel was used to replace carbon steel, significant decrease in bond strength was observed. From the current test results, it is recommended that suitable measures need to be taken to increase the bond strength if the column size is very large and/or the concrete has a high shrinkage potential. Key words: Structural Engineering; Concrete-filled steel tubes; Stainless steel; Bond strength; Push-out 30 0 Introduction The concept of concrete-filled stainless steel tubular (CFSST) construction was put forward only a few years ago [1-3]. It can utilise the beneficial material properties of both stainless steel and concrete. Thus, the durability and aesthetic appearance of the composite construction can be 35 40 45 greatly improved, whilst the increased initial cost of using stainless steel can be offset by the relatively low cost of concrete and the reduced maintenance cost in the life-cycle of the structure. For the above reason, the CFSST construction has received increasing interest from the resear