基于Moldflow 的复印机转印支架热流道注塑方案对比研究.pdfVIP

1 40 8 Vol.40No.8 50 2012 8 ENGINEERING PLASTICS APPLICATION Aug. 2012 doi:10.3969/j.issn.1001-3539.2012.08.012 Moldflow * 1. 541004 2. 250031 TQ320.6 A 1001-3539(2012)08-0050-04 Comparative Studies on Injection Molding Projects with Hot Runner for a Copier Bracket Based on Moldfl ow 1 2 库 Liu Chaofu Zhao Zhihong 1. Institute of Information Technology of Guilin University of Electronic Technology Guilin 541004 China 2. CNGC Institute 53Jinan 250031 China 例 Abstract According to the defects such as short fillingshrinkage, warpage and so on appeared during the injection molding process for a copier bracket, the injection molding project with double-point feeding hot runner was replaced by the project with single-point feeding hot runner. Then the differences of the two projects with the melt filling states, the pressure distribution at mold 案 cavity and the weld lines qualities of the plastic parts, the temperature at flow frontthe frozen layer fractions and the volumetric E shrinkage when ejecting and so on were analyzed and compared by using Moldflow, the feasibility of the new project was predicted A in theory. Finally, it was proved that the new project had better effect after the practical application in factories. C Keywords Moldflow bracket of copier hot runnner injection molding project 1 模