冷连轧设定控制系统综合优化研究_王晓晨.pdfVIP

网络出版时间：2014-01-07 20:21 网络出版地址：/kcms/detail/11.2187.TH2021.008.html 冷连轧设定控制系统综合优化研究* 王晓晨 杨 荃 孙友昭 (北京科技大学国家板带生产先进装备工程技术研究中心 北京 100083) 摘要：基于现阶段冷轧板形精度要求的提高、板形控制技术的发展与智能控制技术的进步，在传统冷连轧负荷分配研究基础 上，提出了板形板厚张力设定控制系统综合优化计算方法。对板厚、张力进行兼顾板形偏差最小、弯辊裕量最优及负荷平衡 的多目标优化设计，对工作辊弯辊、中间辊弯辊以沿带钢全宽板形偏差最小为目标进行优化设计。优化计算采用具有良好全 局和局部寻优能力的三种群粒子群差分进化算法(Three-populations particle swarm optimization and differential evolution algorithm, Thr_PSODE) 。现场应用结果表明，通过设定控制系统综合优化对轧制规程、张力制度以及各板形调控手段的优化 配置，在兼顾多个优化目标的同时充分挖掘轧机的板形调控能力，实现了对复杂模态的高次板形缺陷的有效的控制，具有重 要的研究价值与应用前景。 关键词：冷连轧；粒子群；差分进化；轧制规程；板形控制 中图分类号：TG334 Research on Comprehensive Optimization of Tandem Cold Rolling Setting Control System WANG Xiaochen YANG Quan SUN Youzhao (National Engineering Research Center of Flat Rolling Equipment, University of Science and Technology Beijing, Beijing 100083) Abstract ：According to the enhancement of cold rolling shape control precision requirement, the development of shape control technology and the improvement of intelligent control technology, shape-thickness-tension comprehensive optimization of tandem cold rolling setting control system is proposed instead of traditional load distribution research. Thickness-tension optimization is executed by the integrated goal of minimum shape deviation, maximum bending force margin and load equalization. Work roll bending force and intermediate roll bending force are optimization designed by the target of minimum shape deviation along strip width. Then three-populations