品质专用中英文对照.docVIP

品質人員名稱類 QC? ?quality control??品質管理人員 FQC? ?final quality control??終點品質管制人員 IPQC? ?in process quality control??制程中的品質管制人員 OQC??output quality control??最終出貨品質管制人員 IQC??incoming quality control??進料品質管制人員 TQC??total quality control??全面質量管理 POC??passage quality control??段檢人員 QA??quality assurance??質量保證人員 OQA??output quality assurance??出貨質量保證人員 QE??quality engineering??品質工程人員 品質保證類 FAI? ?first article inspection??新品首件檢查 FAA??first article assurance??首件確認 TVR??tool verification report??模具確認報告 3B??3B??模具正式投產前確認 CP??capability index??能力指數 CPK??capability index of process??模具製程能力參數 SSQA??standardized supplier quality??合格供應商品質評估 OOBA??out of box audit??開箱檢查 QFD??quality function deployment??品質機能展開 FMEA??failure model effectiveness analysis??失效模式分析 ? ?8 disciplines??8項回復內容 FA??final audit??最後一次稽核 CAR??corrective action request??改正行動要求 ??corrective action report??改正行動報告 FQC運作類 AQL??Acceptable Quality Level??運作類允收品質水準 S/S??Sample size??抽樣檢驗樣本大小 ACC??Accept??允收 REE??Reject??拒收 CR??Critical??極嚴重的 MAJ??Major??主要的 MIN??Minor??輕微的 AOQ??Average Output Quality??平均出廠品質 AOQL??Average Output Quality Level??平均出廠品質 Q/R/S??Quality/Reliability/Service??品質/可靠度服務 MIL-STD??Military-Standard??軍用標準 S I-S IV??Special I-Special IV??特殊抽樣水準等級 P/N??Part Number??料號 L/N? ?Lot Number??特采 AOD??Accept On Deviation??特采 UAI??Use As It??首件檢查報告 FPIR??First Piece Inspection Report??百萬分之一 PPM??Percent Per Million??批號 制程統計品管專類 SPC??Statistical Process Control??統計製程管制 SQC??Statistical Quality Control??統計品質管制 R??Range??全距 AR??Averary Range??全距平均值 UCL??Upper Central Limit??管制上限 LCL??Lower Central Limit??管制下限 MAX??Maximum??最大值 MIN??Minimum??最小值 GRR??Gauge ReproducibilityRepeatability??量具之再制性及重測性判斷量可靠與否 DIM??Dimension??尺寸 DIA??Diameter??直徑 FREQ??Frequency??頻率 N??Number??樣品數 其它品質術語類 QCC??Quality Control Circle??品質圈 QIT??Quality Improvement Team??品質改善小組 PDCA??Plan Do Check Action??計劃 執行 檢查 總結 ZD??Zero Defect??零缺點 QI??Quality Improvement??品質改善 QP??Quality Pol