混凝土结构粘结性能的系统试验方法的研究.pdfVIP

第七届全国土木工程研究生学术论坛 东南大学 2009 混凝土结构粘结性能的系统试验方法研究 1,2 2 蒋德稳 ，邱洪兴 (1. 222005 2. 210096) 淮海工学院 土木工程学院 江苏 连云港 ； 东南大学 混凝土及预应力混凝土教育部重点实验室 江苏 南京 摘 要：为了研究钢筋与混凝土之间粘结性能，本文对粘结性能系统试验方法进行了研究。综合评价应用了近30年的粘结 标准试验方法（GB50152-92）。对比分析了中心拔出试验、中心对拉试验、全梁式试验、半梁式试验、模拟梁式试验和裂 缝间粘结试验方法的优缺点及其适用条件。系统研究了粘结与结构性能如弯曲裂缝宽度、挠度、搭接、锚固强度、塑性铰 转动能力之间的关系。提出了单一试验方法研究粘结性能是不充分的。得出了粘结性能系统试验方法的基本要求，包括粘 结试验形式、混凝土对钢筋的约束水平、钢筋与混凝土之间粘结长度、粘结试验测定的变形量。本文提出的粘结性能系统 试验方法可以为研究混凝土结构性能提供技术支持。 关键词：粘结性能；梁式试验；拔出试验 Aseismic Behavior of Modern Building Flat Shell Element Jiang Dewen1,2, Qiu Hongxing2 (1 HuaiHai Institute of Technolgy, College of Civil Engineering, Jiangsu, Lian yungang 222005, China 2 Southeast University, Key Lab of RC PC Structures of Ministry of Education, Jiangsu, Nanjing 210096, China) Abstract: In order to study the bond performance of rebar and concrete, the system of testing method on the bond behavior is investigated. Chinese pull-out test of cubic specimens (GB50152-92) is comprenhensively reappraised which has been applied for about 30 years. The relative merits and application condition of central pull-out test, central mutual pull test, full beam style test, semi-beam style test and simulation beam test are analyzed comparatively. The relation between bond and structural performaces (such as bending crack width, deflection, lap length, anchoraging strength and rotation capacity of plastic hinges is systematically studied. It is demonstrated that a single measure of performance) was inadequate. The basic requirement of the system of testing method on the bond behavior is put forwards. It includes bond test forms, the constraint level of