高强IF钢GA板镀层组织及抗粉化性能研究.pdfVIP

高强IF 钢GA 板镀层组织及抗粉化性能研究 1 1,2 1 王川 ，滕华湘 ，康永林 (1.北京科技大学材料学院，北京 100083 ；2.首钢技术研究院薄板所，北京 100043) 摘要：本文研究了工业化大生产条件下不同合金化温度的高强 IF 钢合金化热镀锌板抗粉化性，采用扫描电镜（SEM）对镀层表面 及截面微观组织进行观察，同时利用 x 射线衍射法（XRD ）对镀层相结构进行测定，并通过辉光放电光谱法（GDOES ）对镀层中 Fe 及主要元素含量进行定量分析，最后对样品进行 60°V 弯试验以检验镀层抗粉化性能。结果表明，对于所研究的高强 IF 钢合金 化镀锌板，合金化功率较低时，镀层表面以 δ相为主同时还有部分 ζ相；合金化功率较高时，镀层表面由致密的 δ相组成；随合金化 功率提高镀层粉化量增大；当镀层表面及次表面的相结构是以 δ相为主同时含有部分 ζ相时其抗粉化性较好；对于实验用钢，在其 他条件不变的情况下，合金化温度在 500℃~550 ℃范围内可得到抗粉化性较好的镀层。 关键词：合金化热镀锌，高强IF 钢，抗粉化性，合金化温度 Research on the texture and powdering resistance of industrially produced galvannealed coating on high strength IF steel 1 1,2 1 WANG Chuan , TENG Hua-xiang , KANG Yong-lin (1. School of materials science and engineering, university of science and technology Beijing, 100083, China; 2. Shougang Research Institute of Technology Beijing, 100043, China) Abstract: The microstructural and textural aspects of the coatings on industrial galvannealed high strength interstitial free (IF) steel with different galvannealing temperature have been investigated by means of scanning electron microscope (SEM), X-ray diffraction (XRD), glow discharge optical emission spectrometry (GDOES). Then 60 degree V-bending test was carried out to study the powdering resistance behavior of the coatings. The results showed that, for the galvannealed high strength IF steel which have been studied, when the galvannealing temperature is 500℃, the surface of the coating is consist of δ and ζ phase while the majority of which is δ phase; when the galvannealing temperature is 550 ℃ and 580 ℃, the surface of the coating i