专业英语(英语科技论文results写法)介绍.ppt

Results and discussion 第七小组成员：丁艳然、申妮、刘迪、 张益飞、王晓燕、齐园园、于梦妍、 石进荣、赵高杰、陈冬、刘文帅 主讲人： XXX Table of Contents Example 1 Introduction of results 2 Description of important results 3 Discussion of results 4 Templates 5 Results Example 1 The separator should have uniform pore size distribution to avoid performance losses, which is due to uneven current densities. Some research shows that sub-micrometer pore dimensions are critical for preventing internal shorts between the anode and the cathode of the lithium-ion cell, particularly as the separators are as thin as 25 mm or less. The influence of PPTA pulp dosage to the maximum and average pore size of separator is shown in Figure 3. With the increase of PPTA pulp dosage, the maximum pore size and average pore size of the separator remain on a downward trend. When the PPTA pulp dosage reaches 40%, the pore size of the separator is decreased obviously. The pore size of the separator can be well controlled to less than 1 mm. 该隔膜应孔径分布均匀，以避免由于不均匀造成性能损失。研究表明，亚微米孔隙尺寸是针对预防性内部的阳极和锂离子电池的阴极之间的短路的关键，特别是隔膜是薄如25毫米或更小的。PPTA浆液剂量对隔膜最大和平均孔径的影响示于图3。随着PPTA浆液剂量的增加，最大孔径和平均孔径都呈下降的趋势。当PPTA浆液剂量达40％时，隔膜的孔隙尺寸明显减小，隔膜的平均孔隙尺寸可以很好地控制到小于1mm。 Figure 3. The influence of PPTA pulp dosage to the pore size of separator. 图3 PPTA剂量对隔膜的孔径的影响 Example 2 The pore size distribution of the separators with PPTA pulp dosage ranging from 20% to 100% is shown in Figure 4. It can be seen that the pore size distribution is not continuous. Parts of large pores appear near the maximum pore size, and another centralized zone of scatter is near the average pore size. The reason for the discontinuous distribution of the pore size might be that the maximum pore size depends on the coarsest fibers diameter and the defects of nonwoven, but the average pore size depends on the most common fiber diamete