installationoftheon-boardcomputer- veramon（installationoftheon已-凡拉蒙）.docVIP

Installation of the On-Board computer Astra G  The module is installed on the imaging display (TID), which is located in the upper center console, which must therefore be removed. It is necessary to remove the module on-board devices, where the power cable assembly connects the measurement of engine speed and the condition of the fuel tank, then stretch and attach wire to the engine control unit and replaced the right control stick for steering. Before the installation is recommended that you disconnect the car battery. Removing the center console: - Remove the radio and storage space (the drawer under the car radio) - Remove ashtray and remove the cover of a car cigarette lighter - Allow the screws under the cover of a car ashtray and lighter - Remove the metal shaft radio (on the back is screw) - Cut to the car stereo connectors, including the antenna connector - Allow the screws on the sides, where they found the shaft radio - Disconnect the control air-conditioning (2 clips at the top and bottom 2 clips) - Pull switch to remove the directional warning lights  Now we no longer cover the entire center console holds the upper metal clip, making it stronger by pulling out and then pull out. - Push out the plug warning light - Disconnect connector from the display TID Removing the panel board instruments: - Take off two covers at the bottom of the flight instrument - Allow four screws (2 below and 2 above) - Push out the plastic cover on-board instruments - Allow the screws that hold the board device (2 below) - Disconnect connector (top left of the lever is plastic) - Remove the panel board instruments - Remove the connector cable assembly from the cradle  To remove the connector to the cable assembly from the holder, it is necessary to squeeze plastic holder at the bottom left downwards. Connector beam can then be easily pulled to the left out Removing control - Pull the two plastic screw covers on the steering wheel (it is necessary