04-MSB 440V.docVIP

Main switchboard 主配电板 Measurement of insulation resistance In condition of that all the switches of the main switchboard are off. Measure the insulation resistance between the bus and earth with a DC 500V megohmeter. (not less than 1M() 1.1绝缘电阻试验 在所有主配电板上的开关处于断开位置时，用直流500伏兆欧表测量汇流排对地的绝缘电阻（不小于1M(）。 Test of protection control system according to maker’s standard. Embody can reference PMS test program and USTEIN ELECTRIC AS supply’s Main switchboard test program. 1.2按制造厂标准进行保护和控制系统的试验。具体可参考PMS试验程序和USTEIN ELECTRIC AS提供的主配电板试验程序 1.2.1 Reverse power relay trip test Reverse power relay start to work properly and the air circuit breaker opens in a setting time. Setting of reverse power: 10% of rating power (182.5kW) Setting time: 4s The above results are recorded in attached sheet table 1-1. 逆功率继电器必须正确地延时动作，空气断路器延时断开。 逆功率设定值： 10％额定功率（182.5kW） 设定时间： 4秒 记录表1-1 1.2.2 Under voltage tripping test 35~70%. The above results are recorded in attached sheet table 1-1. 欠压脱扣试验 35%~70% 记录表1-1. 1.2.3 Test of over-current relay Simulation current of secondary circuit of current transformer is used for the test of tripping devices where no overload is caused on the prime mover. The over-current device of the air circuit breaker shall be fed with currents as mentioned below and it shall be confirmed that the device starts to work properly and the air circuit breaker opens in a setting time. Setting of current and time: A/20s The above results are recorded in attached sheet table 1-2. 过电流继电器脱扣 在不引起原动机过载情况下，用电流互感器的二次回路的模拟电流进行过电流继电器脱扣试验，空气断路器过流装置调整在下列设定值，确认其动作正确，且空气断路器延时断开。 电流设定值： A/20S 记录表1-2 1.2.4 Test of over-current relay for preferential trip Setting: A/10s The above results are recorded in attached sheet table 1-3. 优先脱扣： 电流设定值 A/10S 记录表1-3 synchronizing of generators to be tested by manual 1.2.5 发电机组手动同步试验 Inspection ACB, MCB etc of MSB. 检查主配ACB、MCB开关等。 Interlocking function test The fu