LCD1602_显示时间_温度.doc

#includereg52.h #includeintrins.h #define uchar unsigned char #define uint unsigned int #define LCDIO P2 sbit DQ=P1^3;//ds18b20与单片机连接口 sbit rs=P1^0; sbit rd=P1^1; sbit lcden=P1^2; sbit acc0=ACC^0; //移位时的第0位 sbit acc7=ACC^7; //移位时用的第7位 uchar second,minute,hour,day,month,year,week,count=0; uchar ReadValue,num,time; uint tvalue;//温度值 uchar tflag; uchar code table[]={ 2010-11-29 MON}; uchar code table1[]={ 15:45:00 000.0C}; uchar code table2[]= THUFRISATSUNMONTUEWES; uchar data disdata[5]; sbit DATA=P0^1; //时钟数据接口 sbit RST=P0^2; sbit SCLK=P0^0; sbit menu=P3^5; //菜单 sbit add=P3^6; //加一 sbit dec=P3^7; //减一 void delay(uint z) { uint x,y; for(x=z;x0;x--) for(y=110;y0;y--); } void delay1(uint z) { for(;z0;z--); } void write_com(uchar com) { rs=0; rd=0; lcden=0; P2=com; delay(5); lcden=1; delay(5); lcden=0; } void write_date(uchar date) { rs=1; rd=0; lcden=0; P2=date; delay(5); lcden=1; delay(5); lcden=0; } void init() { uchar num; lcden=0; write_com(0x38); write_com(0x0c); write_com(0x06); write_com(0x01); write_com(0x80); delay(5); write_com(0x80); for(num=0;num15;num++) { write_date(table[num]); delay(5); } write_com(0x80+0x40); for(num=0;num15;num++) { write_date(table1[num]); delay(5); } } void Write1302(uchar dat) { uchar i; SCLK=0; //拉低SCLK，为脉冲上升沿写入数据做好准备 delay1(2); //稍微等待，使硬件做好准备 for(i=0;i8;i++) //连续写8个二进制位数据 { DATA=dat0x01; //取出dat的第0位数据写入1302 delay(2); //稍微等待，使硬件做好准备 SCLK=1; //上升沿写入数据 delay1(2); //稍微等待，使硬件做好准备 SCLK=0; //重新拉低SCLK，形成脉冲 dat=1; //将dat的各数据位右移1位，准备写入下一个数据位 } } void WriteSet1302(uchar Cmd,uchar dat) { RST=0; //禁止数据传递 SCLK=0; //确保写数居前SCLK被拉低 RST=1; //启动数据传输 delay1(2); //稍微等待，使硬件做好准备 Write1302(Cmd); //写入命令字 Write1302(dat); //写数据 SCLK=1;