Mass spring model based on simulation of tooth movement.docVIP

 PAGE \* MERGEFORMAT 15 Mass spring model based on simulation of tooth movement Study: LIAO Wen and Yu Qing Wang Qifeng Sun Quanping Theoretical Studies] [Abstract] Objective: To study the oral digital virtual orthodontic tooth movement in simulation technology for the production of a transparent process of a series of invisible appliance mold design of digital modeling to prepare. METHODS: First, the use of three-dimensional non-contact measurement equipment acquisition 1:1 full-mouth dental plaster model three-dimensional point cloud data, and digital full mouth dental build digital models, and then using mass spring model to simulate the virtual tooth movement, and finally using VC + +6.0 and Hoops graphics library of virtual simulation software development. Results: The tooth movement, rotating digital simulation method could meet the requirements of orthodontic tooth virtual mobile. Conclusion: Using standard optical measurement equipment, collecting data and dental plaster mold surface model was reconstructed using the mass spring model method of tooth movement simulation is feasible, effective, transparent and invisible for the development of China-made orthodontic appliance production of accumulated experience. [Keywords:] three-dimensional measurement of tooth movement in the spring mass model Abstract: Objective To explore the simulation technology of tooth movement during the virtual orthodontic treatment and help the doctor rapidly design the shape of invisible tooth aligner. Methods Firstly, a plaster model was measured by the 3D optical measuring system and the mesh surface was reconstructed from cloud data. Secondly, the spring mass model was used to simulate the tooth displacement. Finally, the software prototype was developed using VC + +6.0 and Hoops graphics library. Results The movement and rotation of tooth met the requirement of the digital orthodontic treatment. Conclusion The method of tooth movement based on spring mass mo