考前4温习(国外英文资料).docVIP

考前4复习(国外英文资料) Review materials Fill in the blanks 1, CNC machine tools common interference with electromagnetic interference, power supply line interference and signal transmission interference. 2, according to the movement mode, numerical control for point control, line control, contour control. 3, geometric accuracy of CNC machine tools is the comprehensive reflection of the geometry error of each of the key parts of the machine tool and assembly, testing tools commonly used are: precision level, precision square box, square, flat and high precision test bar. 4 、 the interface between NC system and machine tools, machine tools and electrical equipment has four parts. They are position feedback circuit and driving electric circuit 5. NC machine tools PLC input components are: control switch, stroke switch, proximity switch, pressure switch and temperature control switch. The output components are contactor, relay and so on. 6, CNC machine tools mechanical fault diagnosis of the main content, including the machine running state identification, prediction and Monitor three aspects. 7. The service life of CNC machine tools has three stages: initial service period, relative stability operation period and life end period. 8, CNC machine tools including self diagnosis __ diagnosis _, boot from the operation of self diagnosis and self diagnosis of three types of offline. ? 9, CNC machine tools inspection is based on the relevant maintenance documents, CNC machine tools for fixed-point, regular inspection and maintenance. 3, the three routine of troubleshooting is to investigate faults, analyze faults, detect and troubleshoot faults. ? 12, the main purpose of spindle lubrication is to reduce friction, take away the spindle assembly heat, improve transmission efficiency and rotation progress. 13, when the gap between the rails is adjusted, a horizontal platen is used to adjust the horizontal working surface, and the vertical working surface of the guide rail is adjusted by