东芝166维修代码（国外英文资料）.doc

东芝166维修代码（国外英文资料） The document comes from the network, it is oneself collect to organize, if have omission, mistake, still ask everybody to correct! Toshiba 166 maintenance code How do I use the department management function of the Toshiba 163/166 copier Set mode 1 + * the function, can be modified by 8 bit binary on every 0, 1 attribute, to open and close function Code description Functional type code: 100-function 101 - computer function 102 - HOME 2, 100 code 18 where only 2 bytes are set for partial code management (0 does not enable department code, 1 is enabled); The default setting is: 18 code byte 7 June 5 4 3 2 1 1 0 0 0 1 0 0 0 03, instructions for 1 + * boot into feature set mode, the input function type code press the Start button input function Press the Start button The screen displays an 8-bit binary code The start screen display for 6 The code in seventh place will be switched to 5 by pressing the 200% button 4 3 bit code again press 200% button to display 2 one Zero bits of code 2, set up the department code 1, 1 + * boot up, enter 100 Input 18 Then select the second byte to change it to 1 to enable the department code The process of 2, set up department code 8 + Start boot code patterns into the department To enter the new three digital code Press the Start button to confirm The previous input LED screen at this time of the three department code will keep flashing Press the Start button to confirm at this moment, to save department code into RAM, or press the Clear button, do not save To turn it off Note: the department code must be 3 digit code from 001 to 999 If you press the Start button, the input of department code already exists, side a voice prompt, the screen will return to the initial state The process of removing department code 8 + Start boot code patterns into the department Enter three digits department code to delete or press the INTERRUPT key search automatically Press FUNCTION CLEAR key to confirm At this moment the LED screen will