采空区悬顶岩梁模型及其流变分析（国外英文资料）.docVIP

采空区悬顶岩梁模型及其流变分析 Pdf documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Article number: 1003-5923 (2005) 04 - 0084 - 02 Model of cantilever rock beam in goaf and its rheological analysis He Feng, Wang Laigui, Yu (Department of mechanics and Engineering Science, Liaoning Technical University, Liaoning, Fuxin 123000, China) Abstract: the selection of the key layer of the gob roof strata, simplified as rock beam model is analyzed; by considering two for rock due to bending deformation of roof strata make extrusion to produce, the buckling of delay instability; selection can reflect the damage characteristics of rock creep model, general solution using the rheological mechanics, by the corresponding the principle of the improved critical load can reflect the rheological properties of roof strata, discusses the characteristics of creep buckling load time and instability, the delay instability and strata movement and failure law are important to the research of goaf roof. Key words: goaf roof; rock beam model; buckling; delayed instability; rheological diagram; classification number: TD31; literature identification code: A 1 Introduction N, x, XY, y in the formula -- the middle surface forces of H1 stratum. N N- The roof of stope is a combination of lithology, strength and thickness. Located at the bottom of the key layer, its movement and destruction control the activity of the whole rock formation. Because the dip length is much larger than that of the top rock, the rock sheet model of the roof rock can be simplified as rock beam model, as shown in figure 1. In layered rock, because the interlayer bonding force is small, so in the two wall extrusion and upper strata moving down, will the roof strata instability and gob bending, it is one of the important reasons of roof breaking goaf in layered formations. However, in the present study, the bending deformation of the two rock