仪器使用（Instrument use）.docVIP

仪器使用（Instrument use） 1. When the power is turned on, the instrument is not responsive, that is, the lights, lights and digital tubes are not bright. Check whether the power supply voltage and power cord are intact; Whether the relevant fuse is fused; Turn on the power source, the digital table is displayed, but the light source is not bright. Light source lamp damaged, replacement of the same type of halogen lamp (12V30W); The lamp power supply has the problem, check whether the power board has damaged components; If there are no damaged components in the power panel, please check whether there is a problem with the power supply of the power board operation amplifier. The normal should be plus or minus 12V, which is provided by the amplifier stabilized voltage supply. The adjustment tube 4BG2 and 4BG3 in the light source circuit are frequently vulnerable components. The light source is flashing (the digital watch is bouncing, unstable), or the brightness is not controlled. The lighting may be caused by unstable voltage, and the relevant components of the power supply voltage circuit are mainly examined, such as 4C1, 4BG1, 4BG2, 4BG3, 4BG5, 4bg-7 and 4W. This failure is caused by the poor contact contact of 4W. If the light source is not adjusted, the first step should be to check whether the 4BG2 and 4BG3 are disruptive, and the second is whether there is a problem with the 4BG6 integrated circuit, which can be replaced by 5G23A or F007. 4, 100 % normal, but A - C conversion is abnormal. There is a problem with the logarithmic amplification circuit, and there is damage to the key point of 2BG1 ~ 2BG4. We can focus on 5G921. 5, T goes to A transformation. Logarithmic amplifier circuit failure; 2W1, 2W2, 2W4 or failure can be adjusted or replaced. 6. There are also the following situations in which the number is not stable. The preheating time is not enough, the drying agent fails, the environment vibrates and the power supply is unstable. The microcurrent amplifies t