Advanced Metal Processing课件Exercises Serie I.pdfVIP

Advanced Metal Processing Metalen: mechanothermische verwerking 1°) The three graphs below show the evolution of the grain size (KG) as function of time. Explain the observed grain growth in the three cases (tij d = time). KG KG KG tij d tij d tij d 2°) A two-phase Ti-Al-V alloy has to be superplastically deformed in an uniaxial tensile test at 900°C. Which strain rate would you chose? During deformation extensive grain growth is observed. Draw a true stress- true strain diagram for this test. Suppose that the as-received sheet has a strong crystallographic texture. Will this texture change during the superplastic deformation? Why (not)? 3°) A turbine blade (rotating part in a turbine) has to be used at high temperature and has to withstand high centrifugal forces, so it needs a high creep resistance. It is made from a particle reinforced Ni alloy. A team of scientists is discussing the possibility to do the final forming step by superplastic deformation, using a pre-form made by powder metallurgy. At a first glance this doesn’t seem to be a good idea. Why not? (consider the requirements for superplastic forming and the requirements for creep resistance). Can you find a solution for this dilemma? 4°) Draw in a temperature-time diagram the start of recrystallization in alloy AB as function of the temperature. T T A AB %B log (time) Advanced Metal Processing Metalen: mechanothermische verwerking 5°) Which texture would you expect in a cold drawn Ag-wire? How would the substructure look li