经济学专业（Economics major）.docVIP

经济学专业（Economics major） 1. wind load The standard value of wind pressure calculation formula is: WK= Z s Z W. beta: beta z=1+ zeta phi z/ V Z in the new standard, the basic pressure Wo increased slightly, and the construction of the wind pressure height coefficient E, fluctuating amplifying coefficient, fluctuation influence coefficient are the decrease of V. Therefore, the standard value of wind pressure calculated according to the new specification may be larger than the 89 standard and may be smaller than the 89 standard. The specific changes include the following: 1), the basic wind pressure: new load specification will return period wind load basic value from 30 years to 50 years: the provisions of article 3.2.2 of new rules: for high-rise buildings B height or especially important high-rise buildings, should be according to the wind pressure in 100 years by value. 2) ground roughness class: from the original A, B, C class, changed to A, B, C, D class. The C class refers to the urban areas with dense buildings; the D class is a densely built-up urban area with higher housing. 3) the change coefficient of the height of the Phoenix pressure: A, B, C, the corresponding wind pressure height change coefficient is slightly adjusted. The coefficient of variation of the wind pressure height corresponding to the newly increased D class is 20% to 50%. smaller than the C class 4) the pulse amplification coefficient: A, B, C, corresponding to the pulse amplification coefficient slightly adjusted. The newly increased D class corresponds to a pulse amplification factor smaller than the 89 norm, and approximately 5% to 10%. is related to the material and form of the structure. 5), the influence coefficient of ripple in 89 high regulation, fluctuation influence coefficient and ground roughness category, fluctuation influence coefficient corresponding to A, B, C respectively, 0.48, 0.53 and 0.63. in the new standard, not only the fluctuation influence coefficient and ground roug