辽宁工程技（Liaoning Engineering Technology）.docVIP

辽宁工程技（Liaoning Engineering Technology） A fill in the blank: 1. work in AC rated voltage of 1200 V and below 1500 V and below or DC electrical appliances called low-voltage electrical appliances. 2. according to the object use and control, low voltage electrical appliances can be divided into low-voltage electrical power distribution and low-voltage electrical control. 3. open type load switch must be installed vertically in the control panel or switch board, and the closing state when the handle should be upward, not allowed to flip or paperback, to prevent the occurrence of false switching accident. 4. combination switch ability is low, can not be used to cut off the fault current. For the positive control of asynchronous motor, the motor must be completely stopped after the start to reverse. The 5. electrical fuse is used for short-circuit protection of low voltage distribution network and electric drive systems, when used in series in the circuit to be protected in. 6. fuse for isolation purposes, should be installed in the inlet end of the control switch, and short-circuit protection, should be connected to terminal control switch. The difference between the 7. travel switch and the button is not pressed by finger stroke switch but the use of production machinery parts touch pressure and contact action, so as to convert mechanical signals into electrical signals, to control the mechanical action or as a control program. 8. master controller is mainly based on the use of the environment, the required control circuit number, contact closing order selection. 9. commonly used CJO, CJ10 series AC contactor with rated voltage of 0.85-1.05 times, can guarantee the reliable. 10. common faults of AC contactor is overheating, contact contact wear and contact welding. 11. thermal relay automatically reset the general requirements of not more than 5 min, the manual reset time is less than 2 min. 12. air damping type time relay is also called air bag type time relay, accordi