家庭电路安装（Home circuit installation）.doc

家庭电路安装（Home circuit installation） When I departed, Yang; now I think, the snow. The willow branches on the branches are few and far away, where there is no grass. Mountain air good birds also. Please ask the East flowing water, go and who is good or bad. The net of heaven is large and wide, but it lets nothing through。 Circuit installation specification Temporary power supply shall be provided with complete plug at the construction site. Switch. Socket. Leakage protector shall be installed. Temporary power shall be cable. The power line is divided into three colors: FireWire, red, zero blue, ground yellow. All one-way outlets should be left, zero, right, fire, middle or lit, zero connection. The power supply circuit of each room, the kitchen, the bathroom and the power supply circuit of the bathroom shall be independently used. The leakage protector must be connected with other power supply circuits and shall not overlap its other lines with its zero line. Air conditioning and other high-power appliances, must set up dedicated power supply circuit, air conditioning using 4M2 power line, lighting line using 1.5~2.5M2 power line, all power supply circuit should use 2.5M2 power cord. Other power supply loads refer to this standard. All 20 of the wire into the wall adopt PVC smoldering casing buried, and elbow. Straight section. Wiring connection, the bottom of the box using the cup comb tube can not have joints, can not be exposed in the ceiling on the power line or directly into the wall with cement, in order to ensure the power line can pull or replace. Special circumstances, the power line pipe from the ground through, we should pay special attention to the ground must be used to connect the sleeve tight, in the ground is not allowed to connect the source line, access to the ground must be applied elbow. Before the ground is not closed, we must protect the PVC casing, a rupture injury does not allow the floor tiles of PVC casing should be funded completely covered s