robustness of transmultiplexed imagestransmultiplexed图像的鲁棒性.pdfVIP

Hindawi Publishing Corporation VLSI Design Volume 2007, Article ID 59493, 7 pages doi:10.1155/2007/59493 Research Article Robustness of Transmultiplexed Images ´ Przemysław Sypka and Mariusz Ziołko Department of Electronics, AGH University of Science and Technology, Al. Mickiewicza 30, 30-059 Krakow, Poland ´ Received 31 October 2006; Accepted 9 May 2007 Recommended by Andrzej Napieralski Transmultiplexation changes the parallel transmission into a serial transmission. Integer-to-integer filters ensure the perfect re- construction. The paper presents a suitable serialization method which improves the robustness of images transmitted by a trans- multiplexer system. The solution is based on blocks of sizes adequate to separation filter orders, used in detransmultiplexation. The proposed method results directly from the detransmultiplexation algorithm. An example of a four-channel transmultiplexer system, equipped with integer filters, is presented and analyzed to illustrate the suggested method. A simple and effective filter design method is also presented. ´ Copyright © 2007 P. Sypka and M. Ziołko. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. 1. INTRODUCTION integers to integers. All calculations are provided without di- visions to omit the rounding errors. Due to this propert