非全相运行（Non full phase operation）.docVIP

非全相运行（Non full phase operation） In general the generator is connected or disconnected, prone to non all phase operation, the main transformer is (Y / a - 11) generator circuit wiring, the non all phase operation when there are 2 kinds of situation are as follows: (1) two disconnected, one phase not disconnect: if the main transformer neutral point earthing, the generator three-phase current in two equal or nearly equal to that of another phase current is zero or nearly zero; if ungrounded, the generator three-phase current is zero or nearly zero. (2) when one phase is disconnected, the two phases of the generator are equal or approximately equal, and only about half of the other phase current. (3) the generator negative sequence ammeter indicates abnormal increase. Protection may start. Handle： (1) the generator in parallel, non identical gate, should immediately adjust the generator active and reactive load to zero, the generator and the system; such as splitting off, should all switch immediately disconnect the generator where the bus (including switches, bus connection switch and bypass switch). (2) the generator is disconnected, the non full phase gate, should immediately reduce the generator active and reactive load to zero, all switch immediately disconnect the generator where the bus (including switches, bus connection switch and a bypass switch). When a circuit switch can not be broken, report to the provincial tune, switch off the switch to the other side of the circuit. (3) when the non all phase operation, A, if the demagnetization switch is not tripping, the turbine main steam valve is not closed, is prohibited to manually disconnect deexcitation switch, should immediately reduce the generator active and reactive load to zero, all switch immediately disconnect the motor on the bus (including the section switch, bus connection switch and a bypass switch). B, demagnetization switch is tripped, if the turbine main steam valve has been closed, all should swi