夹具设计(圆周支座).docVIP

夹具设计 Design of a fixture） 1，工件件以一端面和直径13的圆柱外圆柱面为定位基准，采用支撑板和V型块定位方案，其中平面限制了三个自由度，短V型块限制了两个自由度，共同限制了五个自由度，满足了钻孔所需限制的自由度。 1 positioning scheme 工件件以一端面和直径13的圆柱外圆柱面为定位基准，采用支撑板和V型块定位方案，其中平面限制了三个自由度，短V型块限制了两个自由度，共同限制了五个自由度，满足了钻孔所需限制的自由度。 Parts in 13 of the end face and the diameter of the cylinder and cylinder for the locating datum, the support plate and a V-shaped block positioning scheme. The planar restricted three degrees of freedom, the short V type block limits the two degrees of freedom, together five degrees of freedom, meet the drilling required limitations to the self by degrees. 2夹紧机构 运用手动夹紧就可以满足对于生产率的要求。采用压板夹紧机构，通过拧动螺母来实现对工件的表面夹紧。压板夹紧力主要是防止工件在切削力的作用下产生震动。 2 clamping mechanism 运用手动夹紧就可以满足对于生产率的要求。采用压板夹紧机构，通过拧动螺母来实现对工件的表面夹紧。压板夹紧力主要是防止工件在切削力的作用下产生震动。 The use of manual clamping can meet the requirements for productivity. The clamping mechanism is used to realize the surface clamping of the workpiece by the screw nut. Clamping force of the clamp is mainly to prevent the work-piece under the action of the cutting force generated vibration. 3夹具体 由于被加工零件有平行度要求，所以定位平面与V型块在安装时平行度在直径13范围内允许差0.01mm. 没有定位误差。 3 clip concrete 由于被加工零件有平行度要求，所以定位平面与V型块在安装时平行度在直径13范围内允许差0.01mm. Because the parts are processed in parallel, so that the positioning plane and the V type block in the installation of parallel in the diameter of 13 to allow the rror of 0.01mm. There is no position error. Here I use a tighten nut to get the work-piece fixed. This is the fixture of a block I choose. s