电脑横机起底板（Computerized flat knitting machine）.doc

电脑横机起底板（Computerized flat knitting machine） The components of the bottom plate are: 1, needle plate 2, needle plate support 3, compound needle 4, compound needle motor 5, transmission shaft 6, transmission shaft support 7, eccentric bearing 8, outer spherical bearing 9, and sliding rod 10, slider 11, rod 12, crank rod 13, balance block 14, pressure plate 15, spring 16, bearing block 17, synchronous wheel 18, synchronous belt 19, inductor 20, lifting motor 21, chain 22, driving gear 23, the passive gear 24, scissors clamp 25, drive wheel 26, from the floor system Installation requirements: 1, the transmission shaft support installed, the drive shaft activities must be absolutely relaxed and flexible; 2. The synchronous wheel and the synchronous belt should be mounted on the vertical line, so that the synchronous belt is parallel to the slider, and the distance between the synchronous belt and the vehicle wall is equal to about 39mm; 3, the pressure plate will be synchronized with the pressure on the slider, the slider and the end of the car wall must be absolutely straight, or slide the slider will slide up and down when the sliding rod bracket, resulting in lifting and inconvenient and failure, and the left and right slider should be high; 4, the needle board to absolute level, to the gap in the middle of the gap, can not touch the yarn guide, before rising, to ensure that the roller is open state, otherwise it will stamp the transmission belt; 5, in the chain before installation, the balance block under pressure, so that the needle board rising, and then release the hand, needle board to natural whereabouts, that balance, flexibility is very good, otherwise, you must reinstall; Installation standard for scissors and clamps: push the scissors clamp to zero, align the sensor with the magnet steel, and the sensor is bright. Adjustment method: 1, cloth: rise since the end of the needle plate plate to make the hook part of the coil around the surface of the 2mm, motherb