水泥硬化（Cement hardening）.docVIP

水泥硬化（Cement hardening） Cement hardening Catalog Summary chemical process Hydration of silicate cement minerals Hardening principle of cement Causes of hardening of cement Edit this paragraph Summary When the cement is blended with the proper amount of water, it begins to form a plastic paste, which is processable. As time goes by, the slurry gradually loses its plasticity and becomes an immobile compact state, and thereafter the strength of the paste increases gradually until at last it becomes a stone solid of considerable strength. If they were originally mixed with aggregate, such as sand, gravel, cement, they would be cemented together, and become a solid whole, that is, we often say concrete. This whole process we call it cement coagulation and hardening. From the point of view of physics and chemistry, condensation and hardening are continuous and cannot be separated from each other. Condensation is the basis of hardening, and hardening is the continuation of condensation. But in order to ensure the construction quality in the construction, must end the construction before losing its plasticity in the cement paste, so people according to the needs of cement paste and the characteristics of artificially divided into the whole process of setting and hardening process two. Condensation is a process in which the cement is changed from plasticity to non plasticity and has a very low strength. Hardening is the process of increasing the strength of the slurry and resisting the forces acting upon it. In addition, the process of coagulation is artificially divided into initial and final setting, and the time is calculated after adding water. For example, the national standard stipulates that: Ordinary portland cement initial coagulation shall not be earlier than 45min, final coagulation shall not be later than 6.5h. The time during which the irrigation process is applied, Must be earlier than 45min; to the final coagulation, before taking off the template, start the ne