上岗培训资料（Induction training materials）.docVIP

上岗培训资料（Induction training materials） Staff training, assessment content Assembly training contents: (key position: screw and shell) A, screw (batch training content): 1, batch composition Electrically batch power supply connecting wire, electric batch hanging button 2, the kind of batch head Cross electric head six angle electric batch head 3, electric group before use note: Production by designated personnel responsible for the daily production of electric calibrated once, see electric torque size is in accordance with the guide requirements; if the electric torque deviation calibration electric torque, which is in accordance with the instructions of the requirements. And fill out the power calibration record form; such as electric torque calibration found abnormal and can not be put into use, you need to replace the electric group and can be put into use after recalibration. 4, use order and method of electric batch: 4.1. Connect the power supply and the power line of the power supply, and put the power and the power supply. After the above action is completed, turn on the batch switch and check whether the batch can rotate normally 4.2, turn off the power switch, select the required electric screwdriver, check whether there is a batch of electric head wear phenomenon, in recognition of the wear condition of electric head does not affect the normal lock mounting screws under the condition that the number of head electric connecting ring will need to plug installed back at the top of the electric group. 4.3. According to the torsion nut graduation and the color of spring, the torsion spring is selected to obtain the corresponding torque output: 4.4, the torque adjustment nut in approved electrical torque scale in the correct position, using the approved electrical torque tester to adjust torque electric group preliminary test. Test group of electric current torque is within the range of the process requirements. To meet the requirements, can be used normally. 4.4.