学习MMI customer training(principle)学习.ppt

常见问题？ 在没有输油时有流量显示？ 流量计与上位机数据不一致？ 流量计与油罐计量误差？ 在没有输油时有流量显示？ 在没有输油时有流量显示？ 仪表问题 零点漂移 调零不正确 小流量设置过低 外界干扰 回路未调整（上位机有显示而仪表无显示） 工艺问题 阀门泄漏 介质含气，不满管 管线卸压导致的不满管 讨论 谢谢！ * Welcome Latest Developments Introductions * 12/13/96 4 Intro-1 (= Transparency 2) Note: TX-2 depicts a system based on the RFT9739. For the same system with the RFT9712, use TX-144; for the IFT9701, use TX-145. Use TX-2 to orient the class: Point out corresponding components on the PMDs. Don’t spend a lot of time at this point explaining what particular components do or how to operate them. Also, don’t confuse things at this point by using model designations. Make sure class understands the distinction between the transmitter interface (used to communicate with the transmitter but generally not required for normal operation) and the peripheral interface (which is usually the operating interface with the flowmeter). * 12/13/96 4 Intro-1 (= Transparency 2) Note: TX-2 depicts a system based on the RFT9739. For the same system with the RFT9712, use TX-144; for the IFT9701, use TX-145. Use TX-2 to orient the class: Point out corresponding components on the PMDs. Don’t spend a lot of time at this point explaining what particular components do or how to operate them. Also, don’t confuse things at this point by using model designations. Make sure class understands the distinction between the transmitter interface (used to communicate with the transmitter but generally not required for normal operation) and the peripheral interface (which is usually the operating interface with the flowmeter). * 12/13/96 16 Intro-1 (= Transparency 9) Other factors besides temperature and pressure come into play when using most volumetric flow measurement technologies. These factors don’t affect Coriolis. Perhaps the best way to get at this is to ask the question first: Is volumetric measurement affected by other factors? If there’s no response, just give the answer, as shown on the transparency. If the audience has some