英文翻译应用Solidworks进行离心泵叶轮设计.docVIP

Application of the centrifugal pump impeller design Solidworks Abstract: Solidworks software to the impeller shaft plane projection and planar projection mapping, and accurate flow middle decile; of two arc method to draw leaves plane projection angle in the calculation of the relative flow error will result in discontinuity issues leaves correction; Finally, two-dimensional centrifugal impeller modeling, and future fluid analysis software FLUENT and ANSYS finite element analysis software application in research and development of new prospects for the impeller. Keywords: impeller; axial projection; plane projection; Solidworks the structural design of the impeller in Solidworks environment Size of the main structure of the impeller shown in Table 1. Solidworks is a fully parametric feature-based modeling software, Solidworks a variable of the draft outline of the parts drawing and comprehensive modeling capabilities, a sketch or feature-driven parameter changes the size and position, and can automatically check the dynamic process constraints. Therefore, try to use Solidworks software to the impeller shaft and impeller plane projection plane projection mapping, calculated using Excel software to check the flow in the structure after a satisfactory application of Solidworks software to draw two-dimensional sketch of the impeller design modeling . Table 1 Size of the main structure of the impeller Axial surface mapping and inspection of projection In accordance with the axial projection of the shape of the outline sketch, after the completion of draft outline dimensions, dimension driven by changes in the shape outline sketch, and at the same time providing additional relevant geometrical constraints, such as the impeller around the corner at the respective cover outline of the impeller inlet, the flow line to add the front cover tangent constraints, as shown in Figure 1 can be obtained axial projection, the transition can refer to the same type of impeller round to