喷射角对微磨料多相射流加工效果的影响.PDFVIP

Vol. 34 No. 1 安徽工业大学学报( 自然科学版) 第34 卷 第1期 January 2017 J. of Anhui University of Technology(Natural Science) 2017 年 1月 文章编号：1671-7872(2017)01-0049-06 喷射角对微磨料多相射流加工效果的影响 1 2 1 1 1 方 钰 ，时礼平 ，王秀英 ，黄 巍 ，王晓雷 (1.南京航空航天大学机电学院，南京210016 ；2.安徽工业大学机械工程学院，安徽马鞍山243032) 摘要：：针对绿碳化硅微磨料多相射流在加工反应烧结碳化硅表面织构时存在加工效率低、加工一致性差等问题，进行不同喷射 角的绿碳化硅微磨料多相射流加工对比实验，研究4 种粒径的绿碳化硅微磨料在不同喷射角下对反应烧结碳化硅表面织构的 加工效果，讨论喷射角对加工效率提高的影响机理。结果表明，适当减小喷射角可以有效提高微磨料多相射流的加工效率，并 具有减少加工区域内残留凸台的效果。 关键词：：微磨料多相射流加工；表面织构；碳化硅；喷射角 中图分类号：：TG 664 文献标志码：：A doi:10.3969/j.issn. 1671-7872.2017.01.009 Effect of Jet Angle on Multi-phase Micro-abrasive Jet Machining 1 2 1 1 1 FANG Yu , SHI Liping , WANG Xiuying , HUANG Wei , WANG Xiaolei (1. School of Mechanical and Electrical Engineering, Nanjing University ofAeronautics andAstronautics, Nanjing 210016, China; 2. School of Mechanical Engineering,Anhui University of Technology, Ma’anshan 243032, China) Abstract ：：Aiming at the problems of low processing efficiency and poor consistency in the processing of reaction bonded silicon carbide surface texture by green silicon carbide multi-phase micro-abrasive jet machining, comparative experiments on multi-phase micro-abrasive jet machining of green silicon carbide with different jet angles were carried out, the effect of green silicon carbide with 4 kinds of particle sizes on the surface texture of the reaction bonded silicon carbide under different jet angles was investigated, and the effect mechanism of jet angle on the processing efficiency was discussed. The results show that the appropriate reduction of the jet angle can effectively improve the machining