P111 电力线载波资料.pdf

Technical Data Sheet SSC P111 PL Media Interface IC Features • Integrates Power Amplifier and Tri-state functions for CEBus Powerline VSS 1 16 NC (PL) Physical Interfaces VDD 2 15 VSS VSS 3 14 NC SSC • Replaces approximately 30 discrete components to save board space TXO 4 13 CEXT VSS 5 P111 12 NC and increase reliability VDD 6 11 BIAS TP0 7 10 VDD • Implements high-drive Output Amplifier (6 Vp-p into 10 ohm load) to TS 8 9 TXI increase performance under low impedance conditions • Output Amplifier is a Class AB configuration for increased efficiency and lower power consumption • Incorporates built-in over temperature protection circuit for improved system reliability • Serves as companion IC to Intellon SSC P300 and P200 Network Controller IC’s • 16 Pin SOIC Package Introduction The SSC P111 PL Media Interface IC provides the functions of Output Power Amplifier and Output Tri-state Switch for power line transceiver products. The Output Power Amplifier meets the requirements specified by the EIA-600 (CEBus) Standard for output voltage levels into typical and low impedance power line loads and incorporates over-temperature protection for improved system reliability. The IC replaces approximately 30 of the discrete components normally used in support