RD-MW16(16CH)1200W摇头灯说明书.docVIP

Instruction Manual PROFESSIONAL SHOW LIGHT RD-MW16 MOVING HEAD --------------------- Execution 2008------------------ Congratulations on choosing our light! This equipment is powerful in functions with CE Standard. It has been tested through frequent practice in different cases, and well recognized by professional designers in the field of stage light. It fully shows the modern times light characteristic with good performance. It can be used in all kinds of scenes which need high quality lighting. Please read this manual carefully before powering or installing the fixture, follow the safety precautions listed below and observe all warnings in this manual. Warning: always disconnect from mains supply before replacing the lamp. 1. Disconnect the fixture form AC power before removing or installing the lamp, fuses, or any part, and when not in use. 2. Always make the fixture connected to the ground electrically. 3. Do not expose the fixture to rain or moisture. Parameter Lamp：HMI-1200W/S Color wheel:：2colors wheels Size：64*62*91CM Weight:：58KGS Others: 20 DMX512 channels, double color wheel,  LCD DISPLAY INSTALL AND REPLACE LAMP Unscrew the 4 screws at the back of the fixture, then pull out the lamp socket. If changing the lamp, remove the old lamp from the socket. Holding the new lamp, align the small pin on the lamp with the small hole in the socket and insert the lamp squarely. Align the screw holes and fasten the lamp access plate with 2 screws. Please check whether the lamp was fixed tightly. Otherwise, poor connection may lead to short-circuit discharge under high voltage. POWER SUPPLY MAINS Use the plug provide to connect the mains power to the projector paying attention to the voltage and frequency marked on the panel of the projector. It is recommended that each projector be supplied separately so that they may be individually switched on and off. IMPORTANT It is essential that each projector is correctly earthed and that electrical installation conforms