重要：si4432接力传输_repeater的说明_类似zigbee.pdfVIP

AN550 EZMAC PRO® P ROGRAMMING G UIDE 1. Purpose This application note explains how to set up a wireless network using the EZMac and EZHop software stack. Software engineers in particular can benefit from this document, which describes two sample codes in detail, focuses on key solutions, and gives a reference for using the EZMac and EZHop functions and registers. 2. Introduction The EZMac and EZHop software stack is a range of wireless communication software modules for embedded systems using the EZRadio/EZRadioPRO® radio ICs and Wireless MCU ICs. “AN539: EZMac® PRO Overview” introduces the EZMac and EZHop systems and gives a general overview of wireless networks and network protocols. Another document, “EZMac® and EZHop User’s Guide”, describes the details of the EZMacPRO and EZHop software stack while focusing on the operation and application programming interface (API). This programming guide assumes that the user is already familiar with the two documents mentioned above. It explains the operation and key solutions of several sample codes that implement different wireless network topologies using the EZMacPRO:  P2P (point-to-point) demo code  Star demo code The P2P demo code shows how to set up a point-to-point wireless network consisting of three types of nodes: transmitter, forward, and receiver. The transmitter node acts as a sensor node in the field; it wakes up from sleep mode in every second to transmit a data packet. The forward node is for extending the range; it works as a repeater. The receiver also wakes up periodically but adjusts its wakeup timer to the transmitter. The Star demo implements a classic master-slave topology; there is one ma