背靠背感应同步器测角系统的分析-电气工程专业论文.docxVIP

哈尔滨工业大学工程硕士学位论文 - II - Abstract In various types of position measuring device, inductosyn is widely used in electrical industry. The precision of the inductosyn is determined by its own error and the error measurement of inductosyn usually need higher precision measuring devices, so it puts forward higher requirements on precision of measuring devices. Therefore, it is necessary to use a reasonable method to separate the error of inductosyn and to achieve the desired compensation purpose through the establishment of reasonable error compensation model without a need of higher precision angle measuring equipment. The error separation method of inductosyn, combination intercomparsion, has been introduced in this paper combining with the actual situation of the inductosyn measurement. The types of combination intercomparsion are more than one, so two calculation forms of combination intercomparsion have been discussed in this paper and it proves the second algorithm is accurate and the sum of residual squares is minimum. In order to illustrate the correctness of the second algorithm, the origin of the second algorithm is analyzed according to least-square method. At the same time, considering the introduction of actual situation measuring errors, the paper shows that it has correlation of residual errors after error separation and measuring errors introduced by the actual situation, and residual errors can reflect the size of measuring errors. The structure design of back-to-back inductosyn is totally analyzed in this paper. The main purpose of back-to-back inductosyn is to achieve error separation algorithm, combination intercomparsion. A suitable inductosyn structure is put forward based on the actual operation mode of combination intercomparsion. Considering two inductosyn independent rotation, the inductosyn separation of inductosyn rotor and shaft system and the overall installation problem, these problems are analyzed and solutions are given. The main circuit st