草酸铈搅拌槽混合过程的CFD模拟及结构优化-机械工程专业论文.docxVIP

内蒙 内蒙古科技大学硕士学位论文 II II Abstract Crystalline products , which is not new for us, for the basic needs of people now plays a very important role. This will cause us to study mixing equipment. This paper explored a series of mixing equipment. We studied the stirred tank flow conditions, hybrid solid-liquid suspension problems and conditions and check impeller and shaft, etc. this provides a strong basis for industrial mixing equipment in the selection, design and optimization. Study of mixing equipment, fluid simulation using Fluent software, made the following main elements: On the flow field in stirred tank and mixing was simulated, the simulation and experimental data obtained and the results are very consistent with the literature, which verifies the correctness of CFD simulations. On the presence or absence of the baffle and the number of blades were stirred tank fluid dynamics analysis, we compared the effects of their flow field. The complex surfaces have been optimized propeller blades and parametric modeling for rapid modeling provides guidance. And comparing the effects of several common paddle on the flow field in stirred tank and mixed effects. We are highly optimized for the disc turbine impeller, the main point of impact detected by the installation height and installation angle of the stirring blades and other factors effect produced mixing tank. And flow with mounting angles and mounting height were generated to explore, which selects the best installation height under optimal installation angle . Mixing tank for structural optimization flat bottom, we selected the bottom end of the ellipse, toric bottom and cone bottom. And selected the most beneficial effect mixing of bottom structure. On this basis, we simulated the mixing effect which the blade size and location of the feed is generated ,and then worked on a reasonable choice of blade sizes to optimize the design and location of the feed. Completely from the bottom on the critical speed is calculated