二维组合声子晶体薄板振动性能研究结构工程专业论文.docxVIP

关键词：声子晶体、组合结构、振动控制、禁带 Abstract The vibration control of the floor， building walls and so on， Especially of the industrial structure have more prominent meaning. For vibration control theory, the elastic wave bandgap of phononic crystal structure put forward a new approach. however, over the past 10 years, almost all the research in this area have focused on the single crystal structure out of bandgap properties, and in combination phononic crystal structure bandgap properties is almost blank. Using finite element method we simulate bending vibration attenuation and vibration bandgap properties of the two kinds of simple combination of the two phononic crystal structure plate, that is, the two components/ three components mixed phononic crystal structure of the plate. The main contents are, The software debugging and the vibration simulation of the phononic crystal structure of the plate, validate the applicability of the finite element analysis software ANSYS in phononic crystal structure, and that it existe the bending vibration plate Ban-Zone of these two combination of the two phononic crystal structure, and the influence of the vertical structure of the limited number of cycles about vibration attenuation, and more cycle greater attenuation. Through model simulation of the alternating combination phononic crystal structure, ranging from 10Hz to 2400Hz, according to the vibration transmission characteristic curve, we get the vibration bandgap of the corresponding two -dimensional three-components and two-dimensional two-components crystal thin plate structure which have incomparable advantages. Also simulating of the subareaed phononic crystal structure plate, we get that the vibration gap has the a greater impact on district by 3C phononic crystal part. But the bandgaps are more obvious than that 2D3C phononic crystal plate showed, or it shows more obvious vibration attenuation. And the bandgap are also wider than 2D3C structure’. Also comparing the s