流程管理对眼科器械清洗质量的控制效果.docVIP

流程管理对眼科器械清洗质量的控制效果 目的探讨流程管理方法对眼科器械清洗质景控制的应用效 果。方法将514件眼科器械随机分为两组，观察组器械采用流程管理 方法清洗，对照组则采用常规的方法清洗。两组均采用目视法和3倍 放大镜法检査器械清洗合格率及器械损坏率。结果S视法证明器械清 洗合格率观察组(99. 20%)显著优于对照组(94. 50%) (P〈0. 005), 3 倍放大镜法证明观察组器械清洗合格率(97.70%)，而对照组仅为 91.30% (P0. 005)；观察组器械损坏率分别为(1.20%)，较对照组显 著低(3.90%) (1X0.005)。结论采用流程管理方法能有效地提高眼科 器械清洗合格率，降低器械的损坏率，延长器械的使用寿命。 和著作权归原 所有， 匕 关键词：流程管理；眼科器械；清洗；质量 R187 A 1006-1959 (2017) 14-0157-02 The Control Effect of Process Management on the Quality of Cleaning Ophthalmic Device HUANG Cheng-ming， YU Xiao-yuan， LI Shu-ling (Disinfection and Supply Center , Jiangxi Provincial People’s Hospital， Nanchang 330006， Jiangxi, China) Abstract： Objective To investigate the method of process management application of ophthalmic instruments cleaning quality control. Methods 514 ophthalmic device were randomly divided into 2 groups, the observation group was subjected to cleaning process management method, the control group with routine cleaning method. Two groups were used visual method and 3 times magnifying glass method to check the equipment clearance rate and equipment damage rate. Results The visual observation group (99. 20%) was significantly better than the control group (94. 50%) (P0. 005)，3 times the magnifying glass to prove the observation group cleaning pass rate (97. 70%), while only 91. 30% of the control group (P0. 005)； observation group equipment damage rate respectively (1. 20%)，significantly lower than the control group ( 3. 90% ) ( P0. 005 ) . Conclusion The process management method can effectively improve the eye cleaning pass rate, reduce the equipment failure rate, prolong the service life of the device. Key words: Process management； Ophthalmic equipment； Cleaning； Quality 显微手术器械的清洗、维护要求高，如果清洗过程不规范，则直 接影响手术效果［1］。出现术后感染，其原因是清洗不合格，导致灭菌 不彻底。此外，清洗不彻底，残留血迹、污渍，容易形成锈斑，缩短 器械使用寿命。目前，越来越多的医院采用流程管理方法清洗手术器 械，取得；r较好的结果。流程管理是一种以规范化的构造端到端的卓 越业务流程为中心，以持续的提高技术能力为h的的系统化管理方法， 该院消毒供应中心从2016年4月?10月对集中处理的眼科器械清洗 采取流程管理方法并与传统方法进行对比，现报道如下。 1资料与方法 1.1 一般资料 纳入2016年4月?10