单热源供热系统二级网调峰热源设置优化研究-供热、供燃气、通风及空调工程专业论文.docx

单热源供热系统二级网调峰热源设置优化研究 单热源供热系统二级网调峰热源设置优化研究 AN OPTIMIZE STUDY OF SETTING PEAK-SHAVING PLANTS WITH SECONDARY NETWODK IN SINGLE HEAT SOURCE SYSTEM ABSTRACT Nowadays, the proportion of building heating energy consumption is larger, the investment of heating system infrastructure is increasing, and energy-saving work has been paid more and more attention. In order to save project investment, reduce heating energy consumption, keep heating systems operation safe and stable, This article had exploratory research for optimization and updating of the heating system by setting up peaking boiler with secondary network in single heat source heating system. Firstly, the study introduces the development of heat supply status in China, heating energy consumption and energy-efficient ways, performs a new type of heating method - heating system with secondary peak-shaving plants, and then establishes the main system parameters. This paper, combined the diagram of heat load duration, analyzes the economy of heating system with secondary peak-shaving plants, the optimal ratio between the heat load of the first and the total system is determined by the minimum sum cost that energy and non-energy of the heating system within a life-cycle as the objective function, that is the best primary source of heat-capacity coefficient α.. Taking an ideal model of Shijiazhuang for example, the optimal α value is respectively sought by using gas-fired boilers and electric boiler heating system as peak-shaving heat sources in the secondary heat supply network and the economy of the two heating models are compared. By comparison, gas-fired boiler could save more investment costs, yet, the operation of electric boiler is more complex and the running cost is higher for the character of peak and valley and electric load. Then, the coefficient α is considered in the different heating district and scale of heating supply, what’s more the work analyzes the influence of factor on the coefficient α, such as th