elid磨削模糊控加工系统的关键技术研究-机械电子工程专业毕业论文.docxVIP

浙江工业大学硕士学位论文高工艺指标、提高自动化水平为目标。 浙江工业大学硕士学位论文 高工艺指标、提高自动化水平为目标。 最后，采用研制的ELID磨削智能加工系统进行了对硬质合金的磨 削实验，结果显示相对于原有系统，智能加工系统的动态响应以及稳 定性都有明显提高。 关键词：ELID磨削，氧化膜，加工检测，模糊控制 本文获国家自然科学基金项目资助 浙江工业大学硕士学位论文STUDY 浙江工业大学硕士学位论文 STUDY ON ELID GR n①n叮G INTELLIGENT MACHDⅡNG SYST：巳M AB STRACT High surface quality and machining efficiency of hard and brittle materials such as single crystal silicon，tungsten carbide are required by the rapid development of electronic and optical materials．Electrolytic In—Process Dressing(ELID)，which could achieve hi曲efficiency and super-smooth surface，has been attached much importance in science research and industry fields gradually． ELID has many advantages such as hi曲efficiency and accuracy, superior surface quality,and it could be simply applied and adaptive to many kinds of materials，especially its distinctive superiority for ceramic， tungsten carbide etc．This advanced grinding technique will be the maj or development tendency in super-precision machining field． This dissertation firstly aims to combine artificial intelligent(AI)and microcontroller technique to ELID grinding．On the base of accumulated machining experience and optimized processing parameters，all ELID machining system，which could detect the change of machining process and real—time control the process，Was developed．The obj ective of the AI 浙江工业大学硕士学位论文system 浙江工业大学硕士学位论文 system is to optimize machining process and improve automation level． The mechanism of oxide layer on the wheel surface during ELID processing was emphasized，the grinding state was proposed to be characterized with electric current in this dissertation．And the relationship between electric current and ground surface has been studied．The ELID machining is a typical nonlinear and time—varied process，based on identifying the machining state，fuzzy control rules was established through simulation on MATLAB software，and an ELID intelligent grinding system has been developed by adopting microcontroller technique。 Finally