西门子300PLC从入门到精通的100个经典问题及解答.docVIP

西门子300 PLC从入门到精通的100个经典问题及解答 1: how to avoid communication failure messages when using CPU 315F and ET 200S? Using the CPU S7 315F, ET 200S, and the fail-safe DI/DO module, you will call the 0B35 fault security program? Also, you have received the default setting values for all monitoring times and are willing to receive ^communication failure，/ messages? OB 35 defaults to 100 milliseconds? You，ve set the F 1/0 modules F monitoring time to 100 milliseconds, so at least every 100 milliseconds you have to address an 1/0 module? But because the 0B 35 is called every 100 milliseconds, there is a communication breakdown. To ensure that the 0B35 scan interval is different from the F monitoring time, make sure that the F monitoring time is greater than the ob-35 sean interva 1. The S7 distributed security system, all the way up to V5? 2 SP1 and 6ES7138 -4fa00-0ab0, 6 es7138-4fb00-0ab0, 6es7138-4cf00-0ab0. In the new module, the F monitor time is set to 150 milliseconds? 2: what is the monitoring time for the s7~300 CPU on PROFIBUS when the DP is not available? When the DP on the CPUs PROFIBUS interface operates on the PROFIBUS network from the station, it is hoped that the expected configuration and the actual configuration will be matched during startup. The Startup TAB in the CPU properties dialog gives two different times? 3: how to determine power or buffer error, such as battery failure? If an error in the power source (s7~400) or buffer triggers an event, the CPU operating system accesses the 0B81 ? After error correction, revisit 0B81? In case of battery failure, if the batt? indie switch is activated in the battery test, the s7-400 only accesses 0B81. If there is no configuration 0B81, the CPU will not go into operation STOP? If the 0B81 is not available, the CPU is still running when the power source fails? 4: what should be paid attention to when assigning an I/O module (centralized or distributed) to the s7cpus? Please note that created the data area (e. g., a