MS-6149(S)公制外螺纹钢紧固件(克莱斯勒标准中英文对照).docVIP

DAIMLERCHRYSLER CORPORATION No: MS-6149S Material Standard Date Published: 2003-09-23 Category Code: X-1 Change: AA EASL Req.: No RESTRICTED: No METRIC SERIES EXTERNALLY THREADED STEEL FASTENERS 公制外螺纹钢紧固件 1.0 GENERAL 总则 1.1 Purpose 目的 This standard describes the requirements for metric series externally threaded steel fasteners for property classes 4.8, 8.8, 8.8A, 9.8, 9.8A, 10.9 and 10.9A. Tapping screws, thread rolling screws, self drilling and tapping screws, and set screws are not included. 本标准描述性能等级为4.8，8.8，8.8A，9.8，10.9级的公制外螺纹钢制紧固件的要求，不包括自攻螺钉，挤压螺钉，自钻自攻螺钉，和定位螺钉。 1.2 Coverage of this Standard 本标准覆盖的范围 This standard covers the chemical composition, processing (forming, heat treatment), mechanical properties (methods of testing), surface condition, identification and quality requirements of the finished product. 本标准包括化学成分，过程（成形，热处理），机械性能（测试方法），表面情况，标记和表面处理的质量要求 1.3 Correlation to other Standards 与其他标准的关系 This standard is similar to SAE J1199 and ISO 898-1 standards for metric externally threaded steel fasteners. 本标准与SAEJ1199和ISO898-1对公制外螺纹钢制紧固件标准相似 1.4 Designation on Drawings 图纸的指定 For DaimlerChrysler specification purposes, the Material Standard number and the required fastener property class shall be designated for the six specified property classes as follows: 因为克莱斯勒规定，材料标准号及要求的紧固件性能等级要求应按以下规定指定 MS-6149S-4.8 MS-6149S-8.8 MS-6149S-8.8A MS-6149S-9.8 MS-6149S-9.8A MS-6149S-10.9 MS-6149S-10.9A 1.5 Location of Definitions/Abbreviations/Acronyms 定义的位置/缩写/只取首个字母的缩写Definitions/Abbreviations/Acronyms can be found in Section 9.0 toward the end of this standard. 定义/缩写/只取首个字母的缩写可以在本标准的尾部的9.0节中找到 2.0 MATERIAL CHARACTERISTICS 材料特性 The steel used to fabricate these fasteners shall be made from steel wire, in accordance to approved commercial practices. It shall be uniform in chemistry and quality; clean, sound and free from all surface and internal defects detrimental t