慢走丝电火花线切割机间隙控制系统的研究-机械制造及其自动化专业毕业论文.docxVIP

摘 摘 要 对于慢走丝电火花线切割加工来说，放电间隙控制技术是一项十分重要的技 术，因为这项术能在很大的程度上影响加工的精度和效率。这项技术的关键在于 提高它的分辨能力和加强它的实时性。在本文中介绍了一种慢走丝电火花线切割 机床间隙控制技术，文中详细地分析了控制系统的硬件设计及软件设计。 本文首先介绍了电火花线切割机间隙控制技术的发展状况，分析了当前间隙 控制技术的发展趋势，提出了电火花线切割机间隙控制系统的设计方案。 控制系统分为硬件和软件两大部分。慢走丝电火花线切割机间隙控制系统硬 件设计部分详细介绍了硬件的各个组分，主要包括采样保持电路、A／D转换电路， 以及单片微机接口电路。慢走丝电火花线切割机间隙控制系统的软件则主要是单 片微机汇编语言编写的数据处理程序。 同时本文还依据Windosws2000 WDM设备驱动程序的模型及其结构要求， 编写了控制系统的驱动程序。 关键词： 慢走丝 电火花线切割加工 间隙控制 设备驱动程序 The The Development of Discharge Gap Control System for Wire Electrical Discharge Machining with Slow—Travelling Speed Abstract Discharge gap control technology is important for wire electrical diacharge machining with solw-traveling speed，because this technology have a great effect precision and efficiency of the machining．And the key of this technology is how to improve it’s distinguish capability and teal time competence．So，in this paper will introdance a discharge gap control system for wire electrical discharge machining wim slow-traveling speed．and particularly analyse dardware design and software design ofthis control system． Firtly,in this paper introduce the development status of discharge gap control lechnology for wire electrical discharge machining，analyse the direction of the technology,and advanced the design scheme ofdischarge gap control system。 ’Fhe control sysetm include hardware and software．In hardware section，this paper particularly introduce all components system’s hardware，mainly include sample／hold circuit，A／D converter circuit and Sin西e Chip Micyoco interface circuit． in this control sysetm，the software section mainly is data disposal programme writed with Single Chip Micyoco compile language． At the same time，the driver programme of control system is exploited according to the model and structure ofthe Windows 2000 Device Driver Written by：Liu Zhonglian (Mechanical Manufacturing and its Automation) Directed by：Associate Prof．Guo Lieen Keywords：slow—travelling speed wire electrical discharge machining Dishcharge gap control