两层两跨带施工缝RC框架结构时程分析-结构工程专业论文.docxVIP

万方数据 万方数据 Abstract Two kinds of two layers of two span frame structures were established in this paper, concrete structure and construction joint structure, and low reversed cyclic loading tests on the two kinds of structures have been carried out. It was shown by studied systematically. It was shown by studied that the conducted carefully construction joint has a greater impact on seismic performance than crack and integrity of reinforced concrete frame. In this paper, based on the experiment, using ANSYS to establish two kinds of frame structure model same as the test, one cross is ZJ frame structure and another is DF1 frame structure which has construction joint the end of each layer of the column. Using finite element software apply low reversed cyclic loading on two kinds of model, and verify the correctness of the model. On the basis of the correct model, using the finite element software study the influence of construction joints on the frame structure from two aspects. On the one hand, observe the influence of construction joints damage to the side frame column. In order to reduce the interference of the damage at the end of beam, this paper change the rigidity of the beam on the basis of the correct model, to establish a set of frame structure with strong beam weak column, and apply the horizontal load on the structures. Apply horizontal load on the structure, though observing the damage of the end of column to study the influence of the existence of the construction joint to the column side damage. On the other hand, apply seismic wave to do the time history analysis on structures. By choosing the correct seismic wave, and the seismic wave amplitude modulation, apply different types and different magnitude of seismic waves on the frame structures. By contrast, research the influence of different construction joints on seismic performance of frame structure. KEY WORDS: construction joint; frame structure; low cycled reversed loading; seismic performance；t