后张法预应力混凝土孔道真空灌浆工艺及其应用.PDFVIP

  • 4
  • 0
  • 约1.27万字
  • 约 4页
  • 2019-07-20 发布于山东
  • 举报

后张法预应力混凝土孔道真空灌浆工艺及其应用.PDF

第 22 卷  第 2 期 公  路  交  通  科  技 Vol22  No 2 2005 年 2 月    Journal of Highway and Transportation Research and Development   Feb2005 文章编号 : (2005) 后张法预应力混凝土孔道真空 灌浆工艺及其应用 王超峰 ( 中铁隧道集团有限公司 , 河南  洛阳  471009) 摘要 : 真空灌浆是后张预应力混凝土结构中的一项新技术 , 采用该工艺能有利于减小被灌水泥浆的泌水率和收缩率 , 增强孔道灌浆的密实度 , 从而达到提高预应力混凝土结构的安全度和耐久性的目的。本文主要介绍真空灌浆的原理、 设备、浆体配比、工艺流程和及其在南友公路中的应用。 关键词 : 预应力混凝土 ; 真空灌浆 ; 设备 ; 配比 中图分类号: TU757       文献标识码 : A The Duct Vacuum Grouting of Pre stre ssed Concrete by Po sttensioning Method and Its Application WANG Chaofeng (China Railway Tunnel Group COLTD , Henan  Luoyang  471009 , China) Abstract : Vacuum grouting technique is a new technology in the construction of posttensioned concreteThis technique helps to reduce the bleeding and shrinking rate of cement grout , and increase of the compactness of the duct grouting , the safety and durability of pres tressed concrete structure are improvedThis paper presents the principle , the equipment , the ratio of cement , the techniques processe , the advantage and application in the NANYOU highway project Key words : Prestressed concrete ; Vacuum grouting ; Equipment ; Ratio   后张法预应力混凝土结构普遍采用压力灌浆 , 由 绞线 , 强度为 1 860MPa , 布置如图 1 所示。 于浆体中含有气泡 , 渗水后易腐蚀力筋 , 对于通过灌 浆握裹钢材来传递预加应力给结构混凝土的作用将有 所削弱。在严寒地区 , 这些水会结成冰 , 胀裂构件 , 造成严重的后果 ; 另外水泥浆容易离析、析水 , 干硬 后收缩 , 析水会产生孔隙 , 致使强度不够 , 粘结不 好 , 为工程留下隐患。 1  工程概况 图1   南友公路 C13 合同段箱形梁全部采用后张法预

文档评论(0)

1亿VIP精品文档

相关文档