材料与试验协会 B111-98（2004）铜和铜合金无缝冷凝器管和套圈坯料.PDFVIP

Designation: B 111 – 98 (Reapproved 2004) Standard Specification for Copper and Copper-Alloy Seamless Condenser Tubes and Ferrule Stock1 This standard is issued under the fixed designation B 111; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* NOTE 2— Warning—Mercury is a definite health hazard in use and 2 disposal. (See 12.1.) 1.1 This specification covers seamless tube and ferrule 1 1.2 The following safety hazards caveat pertains only to the stock of copper and various copper alloys up to 3 ⁄ 8 in., inclusive, in diameter, for use in surface condensers, evapora- test methods portion, Section 18, of this specification: This tors, and heat exchangers. Tubes for this application are standard does not purport to address all of the safety concerns, normally made from the following coppers or copper alloys:3 if any, associated with its use. It is the responsibility of the user Copper or of this standard to establish appropriate safety and health Coppe